Sop for Heating Mantle
This Document describes (Standard Operating procedure) Sop for Heating Mantle
Sop for Heating Mantle
I. Purpose & Scope:
- The purpose of this SOP is to lay down the procedure for operation and calibration of Heating Mantle
- This Standard operating procedure shall be applicable for operation and calibration of Heating Mantle used in Quality control laboratory
II. Responsibilities:
- All Quality control personnel shall be responsible to follow and implement this SOP.
III : Introduction and Procedural Part:
General Cleaning :
- Clean the heating mantle with a clean dry cloth every day. Occasionally outer surface with wet cloth dipped in dilute soap solution may be used.
- Precautions has to be taken to clean the instrument immediately with dry cloth to remove the moisture.
Basic Operation :
- Switch ON the main supply of Heating Mantle.
- The red colour display indicate the Heating Mantle is on,
- Set the desired temperature by using thermostat knob
- Put required preparation on Heating Mantle for heating
- Take care at the time of heating sample should not spill on heater.
- Switch off the Heating Mantle after the use.
Calibration :
- Calibration Frequency: Calibration done by external Agency once in Year.