Tunnel conveyor belt speed verification

This article contains procedure of Depyrogenating Tunnel conveyor belt speed verification.

Table of Contents

Depyrogenating Tunnel Conveyor belt speed verification:

The objective of this test is to ensure that the conveyor belt speed meets the requirements as specified requirement.

Mark the conveyor belt with marker.
Select one of the speeds of conveyor through HMI at which qualification to be proceeding.
Start the conveyor and stop watch simultaneously.
Stop the conveyor and stop watch after five minutes.
Measure the distance (in mm) covered in five minutes.
Repeat the process for another two times as to observe the three readings at same speed.
Carry out above process for each speed at which re-qualification to be proceed
Calculate the conveyor speed in mm per minute.
Make the start position and advance signal of the conveyor belt.
Start conveyor belt.
Start the stopwatch when advance signal reaches the start position and run for 1 minute.

Conveyor speed shall not vary more than 2 % of the set speed.

All the observations shall be recorded in Report.

Annexure :

Annexure I : Depyrogenating Tunnel Conveyor belt speed verification format

Annexure I

Depyrogenating Tunnel Conveyor belt speed verification format

Result should be compiled from the Reports

Run	Time	Distance covered by Conveyor (mm)	Speed (mm/min)
Speed selected in HMI : 105 mm/min.
I	5.00 min	525 mm	105 mm/min
II	5.00 min	525 mm	105 mm/min
III	5.00 min	525 mm	105 mm/min
Speed selected in HMI : 100 mm/min
I	5.00 min	501 mm	100.2 mm/min
II	5.00 min	500 mm	100.00 mm/min
III	5.00 min	500 mm	100.00 mm/min

Note : Conveyor speed should be Validated for each Bottle size and accordingly results should be verified.